Home/Services/Low Current & Security
Low Current & Security

Low current systems, installed properly

CCTV, telephony, access control, attendance, barriers and the structured cabling underneath all of it. This is the layer everything else depends on — and the layer most often rushed. We design it, pull it, terminate it, label it, test it and hand you the documentation.

Systems we deliver

The full low current scope

CCTV & video surveillance

Cameras chosen for the scene, not the catalogue — with storage sized to the retention period you actually need to keep.

  • Site survey, camera selection and field-of-view planning
  • IP and analogue systems, indoor and outdoor
  • NVR / DVR installation and storage setup sized to retention
  • Recording schedules, motion and event rules
  • Remote and mobile viewing, securely configured
  • Retention compliance and export procedures

PBX & telephony

Phone systems that route calls correctly on the first attempt — including the hospitality behaviours hotels depend on.

  • PBX installation and configuration
  • IP telephony, SIP trunks and extensions
  • Auto-attendant, IVR menus and hunt groups
  • Voicemail, call recording and reporting
  • Guest room phones and wake-up call integration
  • Handset rollout and user training

Access control & attendance

Who can go where, and who was actually at work — recorded reliably and fed straight into payroll.

  • Card, PIN and biometric readers
  • Door controllers, maglocks and exit devices
  • Attendance machines — supply, install, configure
  • Zones, time profiles and anti-passback rules
  • Visitor management and temporary credentials
  • Direct integration with our HR & payroll software

Parking barriers & gates

Controlled vehicle access for hotels, offices, compounds and industrial sites.

  • Barrier installation and commissioning
  • Sliding and swing gate automation
  • Card, remote, RFID and plate-based entry
  • Loop detectors and safety sensors
  • Intercom and guard-booth control
  • Integration with access control and CCTV

Structured cabling

Cable pulling, network design and termination — labelled and tested, so the next engineer is not guessing.

  • Network design and cable route planning
  • Copper and fibre cable pulling
  • Termination, patch panels and faceplates
  • Rack build, dressing and power distribution
  • Labelling to a documented scheme
  • Certification testing and as-built records

Digital signage & AV

Screens and sound for lobbies, meeting rooms, auditoriums and production floors.

  • Video walls and signage networks
  • Meeting and conference room AV
  • Auditorium, theatre and stage lighting
  • Interpretation and conferencing systems
  • Learning and training room solutions
  • Content scheduling and remote management
Our standard

The difference is in what you cannot see

Any contractor can mount a camera. The difference shows up eighteen months later, when something fails and nobody can tell which cable goes where, the recorder has been overwriting footage after four days instead of thirty, and the installer has stopped answering the phone.

We work to a fixed standard on every job: routes planned before cable is pulled, every run labelled at both ends, every device documented with its address and credentials, storage calculated against your real retention requirement, and a complete as-built handover pack that belongs to you.

1

Survey

We walk the site (or review drawings and photographs for remote scoping) and record what is there, what is needed and what will get in the way.

2

Design & bill of materials

Device counts, positions, cable schedule, storage calculation and rack layout — priced line by line so you can see what you are paying for.

3

Installation

Executed by our local partners under our supervision, to the agreed design, with progress reported as it happens.

4

Configuration & testing

Devices configured and hardened, recordings verified, access rules tested, cable runs certified.

5

Handover & support

As-built drawings, labelling schedule, device inventory and credentials handed to you — then ongoing support if you want it.

Next step

Send us the floor plan — get a real quotation

Drawings, photographs or just a description of the site. We will come back with a design, a bill of materials and a price you can actually compare.